If the kernel didn’t load the driver, you must install it using an Ethernet connection. Here is the Official Linux Wireless Wiki: your wireless card is compatible with Linux, you can start with netctl configuration. This command is to check if kernel loaded the driver for wireless card. The output must look like this: Before configuring a connection with netctl you must check the compatibility of your network card with Linux. Run the command – ip link set interface down Setup A Wi-Fi Using netctl: Note: Where an interface is the network interface that you found using the above iwconfig command. Now move down to look for your WiFi network. Run the command to search the available WiFi networks. Run the command to know the name of your network interface – iwconfig Note: You must be root for all the configurations, also you can use sudo.Īlso Read – Arch Linux Take Your Linux Knowledge To Next Level Scanning Network So we’ll use netctl, it’s a cli-based tool used to configure and manage network connections via profiles. There are a lot of programs to setup a wireless connection in Linux, we could use ip and iw to configure an Internet connection, but it would be a little complicated for newbies. In this article, I’ll walk you newbies through the step-by-step setup guide to connect your Arch Linux to your WiFi network.
Though the process is slightly straight forward. If you’re using Linux distro other than Arch CLI then it’s one of the toughest tasks to setup WiFi on Arch Linux using the terminal.